Saturday, October 4, 2008

I Made a Really Big D20



While showing a friend of mine some of the things I've made recently he asked me if I could make a big D20 (a 20 sided die used in some tabletop RPG games). We tossed around a few ideas for it and it sounded pretty ambitious since I didn't know the angles I'd need. I got a couple pieces of poplar 1x6, cut them into 20 equilateral triangles, put did some test cuts with a table saw until I got the right angle to put on the inside edge, and then had all the pieces done.

To attach them together used masking tape to put together 3 sections, the top, bottom, and middle belt, and used wood glue to hold it together. While the glue was still wet I put the three sections together, then balanced a weight on top to press the pieces together for a tighter seam.

The numbers were printed out, cut and taped in place. Then I used a square tip screwdriver to punch them into the wood and painted each number with model paint. After three coats of wood stain it was all done. You can see photos of the build on this Flickr set.

2 comments:

Unknown said...

I've been wanting to attempt a similar project. Did you keep the angle measurements for this d20? Did you find a formula to calculate the individual pieces' angles?

Chris said...

Please give more info.